Feuling Black Aluminum Vented Dipstick for M8 Bagger (3088)
Feuling Black Aluminum Vented Dipstick for M8 Bagger (3088)

Feuling Black Aluminum Vented Dipstick for M8 Bagger (3088)

(No reviews) Write a Review
$320.95
$299.95
(You save $21.00 )
Adding to cart… The item has been added
Description  
  • Screws into the factory oil fill spout as a stock replacement part on M-Eight baggers
  • This breathing dipstick removes unwanted build-up of blow by, which is found in engines with excessive leakdown through the rings/cylinders which is a common issue with large displacement big bore engines
  • Test results show a decrease in engine sump oil levels
  • Two venting style options are available when installing dipstick
  • Dipstick vents excessive pressure from the oil tank through a breather system consisting of a filter element and umbrella valve
  • There are two ways to read the oil level with this dipstick, with the bike on the jiffy stand (FHS) or the bike upright and level (FHU)
  • If reading the dipstick with the bike on the jiffy stand you will take your reading from the dimples labeled FHS (Full Hot Stand)
  • When reading the dipstick with the bike upright and level you will take the reading from the dimples labeled FHU (Full Hot Upright)
  • Made in the U.S.A.
  • Two venting style options when installing dipstick: 1) Use the 1/8 NPT breather vent fitting with internal porous filter element (this option gives a clean look; however it can produce an oil misting/residue out of the element on engines with excessive leakdown/blow by). 2) Use quick-disconnect coupler fitting with rubber hose and filter element (this option will run any excessive oil misting/residue through the line and into the filter element, but does requires disconnecting the fitting in order to check the oil). For option 2, we recommend routing the line up the frame rail, up under the seat/abs area then back down along the right side frame rail and the filter element can fit cleanly between the engine/trans matting area on the inside of the lower right frame rail.
  • The oil pick-up port is on the right side of the engine. Letting the bike idle or warm up on the kickstand will naturally fill the engine case and skew the oil level in the tank.
Compatible Vehicles
Years Make Make Notes
2019-2022 Harley-Davidson Electra Glide Standard FLHT
2017-2019 Harley-Davidson Electra Glide Ultra Classic FLHTCU
2017-2023 Harley-Davidson Freewheeler FLRT
2017-2023 Harley-Davidson Road Glide FLTRX
2020-2023 Harley-Davidson Road Glide Limited FLTRK
2017-2023 Harley-Davidson Road Glide Special FLTRXS
2023 Harley-Davidson Road Glide ST FLTRXST
2017-2019 Harley-Davidson Road Glide Ultra FLTRU
2017-2022 Harley-Davidson Road King FLHR
2017-2023 Harley-Davidson Road King Special FLHRXS
2017-2023 Harley-Davidson Street Glide FLHX
2017-2023 Harley-Davidson Street Glide Special FLHXS
2023 Harley-Davidson Street Glide ST FLHXST
2023 Harley-Davidson Tri Glide Ultra Classic FLHTCUTG
2017-2022 Harley-Davidson Tri Glide Ultra FLHTCUTG
2017-2023 Harley-Davidson Ultra Limited FLHTK
2017-2019 Harley-Davidson Ultra Limited Low FLHTKL

Customers Also Viewed

!