Andrews 37H Series Chain Drive Cams (216337)

ANDREWS - 37 SERIES CAMS FOR TWIN CAM

Andrews Products grinds its cams using computer-aided cam design capabilities. This superior technology gives the utmost in both performance and reliability. Only the best alloy steel billets and heat-treating processes are used. The power in a Harley Twin Cam engine is completely released only when superior Andrews computer-designed high-performance cams are installed.

• Run best with low restriction exhausts (2200-5800 rpm).
• Bolt-in cams have shown 80+ rear wheel HP.
• Smooth idle with broad torque band.
• Works well with carbs or fuel injection.
• Can be used with stock valve springs and tappets.
• Made in the U.S.A.

NOTE: 59G, 60G and 64G cams are for highly tuned engines and require the knowledge of an expert engine builder for proper setup and installation.

NOTE: All Andrews gear-driven cams require four-gear set for installation (DS-199532 or DS-199538 for 99-06 applications; 0925-0166 or 0925-0152 for 07-14 Twin Cam and 06 Dyna applications).

NOTE: Installer must check coil bind, valve-to-valve clearance and valve-to-piston clearance.

NOTE: Chain Driven Cams: 00-06 model cams use a splined cam drive sprocket. These cams will fit in the 1999 Twin Cam motor, but the splined cam drive sprocket OEM #25716-99 or DS-199175 must be used.