Tools

For use on Milwaukee Eight series engines Compatible Vehicles Years Make Make Notes 2018-2019 Harley-Davidson Breakout FXBR 107 2018-2020 Harley-Davidson Breakout FXBRS 114 2017 Harley-Davidson Breakout...

When this adapter is used in conjunction with the main bearing tool, or OE tool, the stator can remain attached to the left side case during bearing installation This adapter is a simple time and money saver when installing the main bearing on a...

Never turn the engine over if the tappet will not spin with your fingers after adjustments were made It is very important that the engine is not rotated while pushrods are tight The pushrod will spin with your fingers after the tappet has bled off ...

Safely installs new main transmission case bearing; does not remove bearing Holds bearing square to its bore, eliminating any marring of bearing bore Made in the USA Compatible Vehicles Years Make Make Notes 2011-2013 Harley-Davidson Blackline...

Removes old bearing straight and will not damage the transmission case Can be used without removing transmission from the bike Made in the U.S.A. Compatible Vehicles Years Make Make Notes 1995-1997 Harley-Davidson Bad Boy...

Holds the main drive gear square to its bearing bore, eliminating any marring of gear or bearings Installs the main drive gear without removing the transmission Made in the USA Compatible...

Removes the main drive gear from the main bearing correctly while in the transmission case Eliminates the need of an arbor press and the risk of case damage Compatible Vehicles Years Make Make Notes 2011-2012 Harley-Davidson Blackline...

Removes hex nut from end of main drive gear that secures the rear drive transmission pulley Extra-long two-piece design Made in the USA Inner collar will retain wrench to nut for safer work. Compatible...

Used to remove and install the inner bearing race on the transmission mainshaft Made in the U.S.A. Compatible Vehicles Years Make Make Notes 1995-1997 Harley-Davidson Bad Boy FXSTSB 2011-2012 Harley-Davidson Blackline...

Tool fits any dual rate or conical valve spring with an O.D. no larger then 1.6" diameter Works with bench vise, arbor, screw hydraulic or drill press 0 to 1000 P.S.I. gauge Made in the U.S.A.

Designed to press oil seal over sprocket shaft into case Made in the U.S.A. Compatible Vehicles Years Make Make Notes 2011-2013 Harley-Davidson Blackline FXS 2013-2017 Harley-Davidson Breakout FXSB 2008-2011 Harley-Davidson Cross Bones...

This tool was designed to help the technician assemble the complete cam chest correctly, in a quick and efficient manner The perfect aid for the technician to either assemble as individual components with supplied studs OR as an assembly with the...