Hand Tools

This multi-function tool will remove and replace front and rear camshafts and the ball bearings in the Twin Cam 88 It provides the precision alignment of the camshaft to ensure a smooth press in...

Very simple tool, just mount tool in cover, screw in the two removing screws, turn center, and out comes the cam seal The new seal is then pressed in with the same tool, square and flat for a no...

Spreads the swing arm cleveblocs allowing for installation of the swing arm Use to install the swing arm in a 5-Speed rubber mount frame Comes with instructions Made in the U.S.A.

Used to remove wet and dry clutch hubs without removing clutch release rod 4 bolts included for dry clutch removal Made in the U.S.A. Compatible

Used to remove and install compensating nut 1/2 in. Drive Made in the U.S.A. Compatible Vehicles

Holds the rods in place when reaming or honing the wrist pin bushings Made in the USA For most V-Twin and Buell Blast applications.

Removes hex nut from end of main drive gear that secures the rear drive transmission pulley Extra-long two-piece design Made in the USA Inner collar will retain wrench to nut for safer work.

Install or remove the closed-end countershaft bearing on all 5-speed or 6-speed transmissions without using a press or tapping it in with a transmission shaft Designed to install the bearing...

Designed to remove and replace the right crankcase bearing Press bearing in and out straight with no damage to the case Made in the U.S.A. Compa