High-grade, lightweight aluminum support plates for two-ply studs Require indexing so edges run parallel with track's edge - a great re-torque indicator For all single and combination...

Woody's entry level carbide runner featuring 4" of 60 degree carbide. Whether you're looking for a replacement runner, a cutting edge in hard-packed snow and ice, or to improve your...

This runner has 6" of 60 degree turning carbide, a great choice if you are looking for overall improvement in safety and handling, or to replace your factory runner. Use with a studded or...

The Standard runner is formed from steel to perfectly fit your ski and add a degree of protection from wear when traveling at very low speeds on delicate terrain. Does not contain carbide or...

Entry-level stainless steel stud, affordable for beginners looking to increase rider safety through traction and control. Resistant to corrosion and will help you stop sooner, take off faster, and...

Carbon steel stud with four flat sides, a patented design, to increase surface area and paddle snow. Through-hardened steel with 60 degree carbide insert 5/16" threads For use in two-ply...

A tool to make studding your track fast & easy! The hex insert fits perfectly into the stud hex to prevent the stud from spinning during installation. Lightweight aluminum Use this tool for...

This runner has 6" of 60 degree turning carbide, a great choice if you are looking for overall improvement in safety and handling, or to replace your factory runner. Use with a studded or...

Slim Profile 1/4"-20 Eliminator T-Nut Steel Studs T-nut style competition stud with a narrow profile for drags, ovals, and speed runs. Its sharp, 30 degree steel tip cuts like a knife...